How to level the FlashForge 3D Printer

Finder creatively adopts three-point intelligent leveling system, which will give clear and comprehensive feedback to users. There are three spring-loaded knobs under the build platform. The distance between the plate and nozzle increases while tightening the knobs and the distance reduces when loosening the knobs.

Tap [Tools] then [Level] on your Finder touch screen.

Please wait while the extruder and platform finish initial movements. After that, operate according to the guide on the touch screen.

If this isn't the initial leveling, you can omit the turning of the nuts counterclockwise and leave as is. Otherwise, turn all knobs counterclockwise.

Press [OK]

Press [YES] on the screen to verify the first point. The extruder starts to move towards the first point and the plate moves up and down to verify the distance between nozzle and plate.

When it shows that the distance is too big/too small, please loosen/tighten the corresponding nut under platform (the picture on the screen will tell you which direction to turn) until hearing the loud beep and press the [Verify] button when it appears. Please follow the prompts to adjust again until you see [OK] button. Follow prompts to complete the same sequence on the second and third leveling points and then Tap [Finish] to exit.

3d 3d print 3d printer flashforge flashforge finder level leveling printer

Creation date: 10/17/2019 2:32 PM Updated: 10/17/2019 2:43 PM

Files		Sort by Name Sort by Date
	DataImage19.png 19.7 KB
	DataImage33.png 12.1 KB
	DataImage39.png 14 KB
	DataImage88.png 22 KB
	DataImage9.png 12.9 KB